Hello!

I just downloaded MQ2 and I love the idea of MQ2, but been looking around for a bit now, and I have to admit it is a bit overwhelimg for me. So if there is anyone here who could help get some macros/hotkeys working I would appreciate that.

For my Rogue for example I'm looking for him to stand behind the target and attack/BS, and not too close if that works

For the casters I kinda know what to do, but is there a way to make them sit down after casting a spell? And also is there a way to make a camp and after the fight they return to that spot?

There is more, but I don't wanna ask for too much.

Any help is much appreciated!

Thanks,
Bob

For your rogue, you need to look at setting up MQ2Melee.

There are good examples of this on the forums here.

In game you can simply type /melee to get a list of the basics.
_________________
Sorvani

Here's a link list for some of the documentation. There is a sticky post around here somewhere with hot keys too.

http://mqemulator.net/forum2/viewtopic.php?t=804

Check out mq2meele as sorvani suggested. For casters mq2cast. Then branch out into remote commands using mq2eqbc, and then remote information sharing using mq2netbots. Once you've got a lose handle on that you can look at macros.

Get a handle on that, and then if you have a specific idea or problem that needs solving post that. It's a really broad program that does a lot so its difficult to answer general questions, you'll get a lot more mileage out of solving a specific problem. Give the forums a quick search first though, its likely been asked :)

I did look around and found some helpful stuff. But my rogue for some reason goes infront of the target instead of behind

More +

/bct Greger //target id ${target.ID}
/bct Greger //stick behindonce
/bct Greger //killthis

Anything I'm doing wrong?

Thanks ;)

The 'behindonce' parameter doesn't keep your rogue behind the mob as the mob moves around or turns around. Use 'behind' or '!front' instead.