I am trying to setup my Shaman controls on my main. I was working on making a hot button for casting his slow and maybe a few DoTs, but the command is not working. The same command works fine for my cleric to cast his heals, but not for shammy, very confused, not sure if an ini setting is turned or what.

The 2 ways I tried to make the hot button:
First way
/bct Shammy //casting "Slow" gem1 -maxtries|3 -targetid|${Target.ID}

After that I just tried
/bct Shammy //target id ${Target.ID}
/bct Shammy //casting "Slow" gem1

I have looked all over, I know my syntax is right, but I still can't figure it out. Any help or point in the right direction would be awesome. Thanks

WG508

what does the shaman do? if anything... are you sure he is connected and can take your commands (i.e. does he do anything at all)?
_________________
for fun

Turn Netbots On, send on, grab on


that may be it. I usally forget on new toons

The format looks correct to me.

If Ulrax's advice doens't work:
Make sure the shammy name is spelled correctly.
Make sure the slow spell name is spelled correctly.
Remove the -maxtries option and retry.
Remove the -targetid and retry after targeting manually.
Try to get the shaman to cast a heal correctly, similar to the cleric heals.
/bct Shammy //echo I can use NetBots!

MQ2NetBots has nothing to do with this.
/bc is MQ2EQBC

If you do /bc Test do you see <toonName> Test in you mq2 window on all toons?
If so, you probably have control disabled.
/bc cmd toggle allowcontol or something like that.
_________________
Sorvani

First off, thanks for all the reply's! Any who, tried grumble's idea about casting a heal, and well that worked. I went a head and tried the slow again, it worked, so I am not sure what I was doing last night that made it not work, but I must be doing something right now. Thanks again for the help. =)