/corpse command
While MQ2 is loaded I cannot use the /corpse command to drag my corpse. It works just fine once I /unload mq2.
Sun Nov 17, 2013 12:17 am
Try "/corps" instead.
It's might be related to another EQEmu/MQ2 corpse incompatibility described here.
It's might be related to another EQEmu/MQ2 corpse incompatibility described here.
Sun Nov 17, 2013 9:35 am
Senior Project Member
/corpse has always worked for me.
_________________
Sorvani
_________________
Sorvani
Sun Nov 17, 2013 3:48 pm
Senior Project Member
Tried it...not working either.
I can target my corpse just fine, I cant drag it while MQ is loaded.
I can target my corpse just fine, I cant drag it while MQ is loaded.
Sun Nov 17, 2013 4:11 pm
Something like this happened awhile back with mq2emumap. If your using the gold build, hit the right alt key, and turn the display of mq2emumap off, then zone out and back in and try /corpse again.
Let me know if that miraculously makes it start working and ill look into fixing it again. I never did figure out what was wrong with it, it was kind of mind boggling. It would work, then not work with me recompiling but not actually changing any code.
Let me know if that miraculously makes it start working and ill look into fixing it again. I never did figure out what was wrong with it, it was kind of mind boggling. It would work, then not work with me recompiling but not actually changing any code.
Mon Nov 18, 2013 6:08 pm
Project Lead
turned map off, zoned out & in, targeted corpse (from a few steps away)...corpse didn't move.
camped out and back in, tried again, no luck.
unloaded mq2, tried again, corpse drags.
camped out and back in, tried again, no luck.
unloaded mq2, tried again, corpse drags.
Mon Nov 18, 2013 10:23 pm